Thingiverse
PLA DRAG CHAIN ALTERNATIVE
von jessefilson94
8
Downloads
4
Likes
0
Makes
THIS IS MY ADAPTATION TO THE 3D PRINTED DRAG CHAIN IN PLA. I'VE NEVER GOTTEN ANY DESIGN TO WORK FOR DRAG CHAINS PRINTING IN PLA BUT THIS TYPE OF DESIGN SEEMS TO WORK INSTEAD OF HAVING EVERY DRAG CHAIN LINK SPLIT IN HALF.
YOU CAN ONLY WEAVE YOUR WIRES IN AND OUT OF EACH LOOP. I'M THINKING THIS WILL WORK WELL WITH BIGGER PRINTERS/CNC.
THE OTHER THOUGHT IS TO ADD A LOOP TO HOLD THE WIRES BUT EVERY LINK WOULD HAVE TO BE PRINTED AT 45 DEGREES TO KEEP EVERYTHING INTACT AFTER SUPPORT.
IF YOU FOUND THIS, READ TO THIS POINT AND THINK IT WOULD BE WORTH THE TROUBLE, LEAVE A COMMENT AND I WILL POST A FILE WITH A LOOP ON THE TOP.
HOPE YOU LIKE IT
YOU CAN ONLY WEAVE YOUR WIRES IN AND OUT OF EACH LOOP. I'M THINKING THIS WILL WORK WELL WITH BIGGER PRINTERS/CNC.
THE OTHER THOUGHT IS TO ADD A LOOP TO HOLD THE WIRES BUT EVERY LINK WOULD HAVE TO BE PRINTED AT 45 DEGREES TO KEEP EVERYTHING INTACT AFTER SUPPORT.
IF YOU FOUND THIS, READ TO THIS POINT AND THINK IT WOULD BE WORTH THE TROUBLE, LEAVE A COMMENT AND I WILL POST A FILE WITH A LOOP ON THE TOP.
HOPE YOU LIKE IT
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
