Thingiverse
PLA dryer roll support
door ZeFrenchie
6
Downloads
0
Likes
0
Makes
This is a rolling support for PLA rolls into dehydrator.
You'll need :
3X Ball bearing model 608
3X Carbon or aluminium 8mm tube 7.5cm long
1X Dehydrator 32cm diam.
1X PTFE tube 20cm long
Don't use PLA to print this thing cause of heat into dehydrator, I made it in PETG but ABS is OK too.
French people, you can find parts here:
Dehydrator rebranded as "Livoo" 245W / €29.90 / Electrodepôt
Carbon tube 8mm diam. / Décathlon
Aluminium tube 8mm diam. / Castorama
You'll need :
3X Ball bearing model 608
3X Carbon or aluminium 8mm tube 7.5cm long
1X Dehydrator 32cm diam.
1X PTFE tube 20cm long
Don't use PLA to print this thing cause of heat into dehydrator, I made it in PETG but ABS is OK too.
French people, you can find parts here:
Dehydrator rebranded as "Livoo" 245W / €29.90 / Electrodepôt
Carbon tube 8mm diam. / Décathlon
Aluminium tube 8mm diam. / Castorama
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
