PLA Replicator Ducted Fan Clips Modded

This is just a slightly modified version of funbarts great idea: http://www.thingiverse.com/thing:40524

It also requires to turn the fan blowing direction by turning the front fans.

Depending on your installed fans you might also have to print the shorter washers from funbarts thing.(Not required for me)

It's outlet is designed to directing the air a little more to the printed model instead on the upper part of the nozzle.

I made the fan collector cap a little wider and a little longer to allow removing the protection grill and almost fetch all air comming from the fans.
The duct itself is not as deep as the original to make sure there is a small gap of 5mm to the front of the printer in warming up possition.

Basically the clips give pretty good results when doing fine PLA prints without the need of an addtitional cooling fan.

For printing material like ABS they have to be removed!

V2 Update requested by user laird to match his needs and nozzle calibration: Bott