PLA temperature towers

*NOTICE* If you downloaded these temp towers before 1 January, 2019, the old file may have been corrupted and there may have been weird gaps between some of the bridges. These new uploads should have solved that, at least when opened in Cura 3.6. Sorry for any issues you may have had using these.

This is a remix of the 3Dmakernoob generic temperature tower. I redesigned them to work within the Worksteel/Sunlu, 3D Solutech, Hatchbox, and Tianse recommended temperature ranges for their PLA filaments (190C-220C, 180C-210C, 190C-210C). I added levels so there would be a broader range available for analysis. I'm sure you could use these tower for other PLAs as well. Each level is a 5 degree drop in temp and the temp each level is printed at is marked on the side of the tower. The following are the heights of each level so you know where to adjust the temperature in your slicer:
base and first level: 0mm - 16.46mm
second level: 16.46mm - 29.92mm
third level: 29.92mm - 43.38mm
fourth l