Thingiverse
plain Magsafe wall mount
von Justus2342
5
Downloads
4
Likes
0
Makes
Additional Material needed:
2x Cylinder Head Screw M3x12 (A little longer or shorter should make no difference)
2x M3 Melt-in thread (like Ruthex M3)
2x ø 3mm countersunk bolt to fix it on the wall.
Print recommendation:
Support: No
Material: PETG, but PLA should be also fine
2x Cylinder Head Screw M3x12 (A little longer or shorter should make no difference)
2x M3 Melt-in thread (like Ruthex M3)
2x ø 3mm countersunk bolt to fix it on the wall.
Print recommendation:
Support: No
Material: PETG, but PLA should be also fine
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
