Planet Token

This is a small (48mm diameter) model of a ringed planet on a stand. I wanted something of this size to use as the first-player token for the board-game Gaia Project. The goal was to make something that would assemble without the need of any superglue, and that would hold together even when transported inside a board-game box. With things this small, I have found that 0.08mm layers with lots of time for cooling produced the best results. After the prints completed, a little cleanup was needed to square the holes in the rings and properly form the clips on the stand. Go conservatively on the clips until the ring snaps on securely! The planet itself should slide easily onto the stand when you're done. Notes: For best topside finishes, rotate the planet 10 degrees so that the hole is down and rotate the rings 12 degrees so that they lay flat.Support is only needed for the planet itself. I tweaked the X-Y clearance for the supports in the slicer so that there was only a thin needle ins