Thingiverse
Planetary gear Parking Disc
von Metalfusion
66
Downloads
110
Likes
0
Makes
Cuts nicely with 2mm endmill. I did the engraving of numbers etc. with 55degree V carving bit. This is quite large (about 16cm x 17cm) so you might want to scale it down a bit.
Please note that this doesn't comply with parking disc standards in Europe so you could get a ticket if you use it.
Please note that this doesn't comply with parking disc standards in Europe so you could get a ticket if you use it.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
