Thingiverse
"Plank" Birdhouse
by Ospi
57
Downloads
38
Likes
1
Makes
REVISION UPDATE: "RB-BH0100-2_Main" replaces "RB-BH0100-1_Main" after an update to the platform lattice fillets.
A Birdhouse designed to mimic that of one created using thin planks of wood (and painted accordingly if one so desires). There is an internal lattice structure which serves as a nesting platform and a separately printed "lid" which I recommend is secured using Velcro so it can be removed to clean inside if necessary.
Recommend drilling a hole in the base to drain water.
- 145 x 138 x 130mm dimensionally
- No supports required (print rear down)
Design is based off this image I found online: http://st.houzz.com/simgs/580105e40d7fe350_4-6228/contemporary-birdhouses.jpg
A Birdhouse designed to mimic that of one created using thin planks of wood (and painted accordingly if one so desires). There is an internal lattice structure which serves as a nesting platform and a separately printed "lid" which I recommend is secured using Velcro so it can be removed to clean inside if necessary.
Recommend drilling a hole in the base to drain water.
- 145 x 138 x 130mm dimensionally
- No supports required (print rear down)
Design is based off this image I found online: http://st.houzz.com/simgs/580105e40d7fe350_4-6228/contemporary-birdhouses.jpg
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
