Thingiverse
Plant Pot Insert
door Jimbo_Jones_
5
Downloads
3
Likes
0
Makes
This is an insert for plant pots that has a hole at the bottom for drainage. Insert this thing in a beautiful plat pot that has no drainage hole. You basically plant your flower/plant/succulent directly in here and then place the thing in your pot. This thing is not visible once it's inside your pot.
I've also included a bottom support to keep the plant and earth away from the pot so that the drainage will actually work.
IMPORTANT: There are two models of the insert, one a typical 3D model while the other one is for use in "vase mode" or "spiral vase mode". Vase mode prints much faster and yields a sturdy enough part for use as an insert.
ALSO IMPORTANT: You need to pay attention to two (2) little things:
1. Drill a hole at the bottom of the insert (or punch it with a blunt instrument!) for drainage
2. Install the bottom support the right way, with the drainage cutouts at the bottom (as shown in photos). Not a huge deal if you place the support upside down, but the idea is t
I've also included a bottom support to keep the plant and earth away from the pot so that the drainage will actually work.
IMPORTANT: There are two models of the insert, one a typical 3D model while the other one is for use in "vase mode" or "spiral vase mode". Vase mode prints much faster and yields a sturdy enough part for use as an insert.
ALSO IMPORTANT: You need to pay attention to two (2) little things:
1. Drill a hole at the bottom of the insert (or punch it with a blunt instrument!) for drainage
2. Install the bottom support the right way, with the drainage cutouts at the bottom (as shown in photos). Not a huge deal if you place the support upside down, but the idea is t
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
