Thingiverse
Plant pot with steps
door richmitch
46
Downloads
40
Likes
0
Makes
a friend saw this design and asked if I could make one.
https://www.etsy.com/au/listing/911908372/recycled-concrete-round-step-terrarium?gpla=1&gao=1&
The one she saw was decorated with little people and tiny cactus
It's 20cm diameter and the steps go close to the centre.
I printed with a raft, to make sure I didn't pick any filament from other prints on the white base, but it should print without if you have a clean enough plate.
https://www.etsy.com/au/listing/911908372/recycled-concrete-round-step-terrarium?gpla=1&gao=1&
The one she saw was decorated with little people and tiny cactus
It's 20cm diameter and the steps go close to the centre.
I printed with a raft, to make sure I didn't pick any filament from other prints on the white base, but it should print without if you have a clean enough plate.
richmitch publiceert ook op
55 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!