Thingiverse
Plant support
di joonsak
10
Download
2
Likes
0
Makes
A simple plant support system with stakes, clips and rings with clips. Rings are made of detachable halves so that it is easy to maneuver them to place.
The stakes have a sharpish bottom end and a stop disc at the bottom for attempted added stability. They are 300 mm tall, which can be printed diagonally on a 220 x 220 mm bed, though they are a bit flimsy that tall, at least on my print settings on PLA+.
No supports or rafts needed.
EDIT 28.5.2024:
- Updated the rings to have a bit more material at a potential weak point where the clips attach to the ring.
- I added another alternate design as version 2. V2 has a ring size of 180 mm and a fixed height of 200 mm above dirt. The sticks are slightly sturdier and the ring slots in a groove at the top of the sticks, thus it is not modular. There are small ridges along the ring for even placements for three or four sticks which helps them stay straight and in place. The ring is open so it can be spread out when placing around the
The stakes have a sharpish bottom end and a stop disc at the bottom for attempted added stability. They are 300 mm tall, which can be printed diagonally on a 220 x 220 mm bed, though they are a bit flimsy that tall, at least on my print settings on PLA+.
No supports or rafts needed.
EDIT 28.5.2024:
- Updated the rings to have a bit more material at a potential weak point where the clips attach to the ring.
- I added another alternate design as version 2. V2 has a ring size of 180 mm and a fixed height of 200 mm above dirt. The sticks are slightly sturdier and the ring slots in a groove at the top of the sticks, thus it is not modular. There are small ridges along the ring for even placements for three or four sticks which helps them stay straight and in place. The ring is open so it can be spread out when placing around the
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
