Thingiverse
Planter Bird Bath
von Japes280
2
Downloads
4
Likes
0
Makes
This is a small bird bath that can be stuck into the soil of a flower pot.
A few pointers:
I'd recommend scaling this model for 140% (or even more if you have big birds flying around).
This can be printed without support although it may struggle some at the center of the bowl. If you encounter issues with it leaking water here, either increase the number of roof/bottom layers or spread some Gorilla glue on the bottom to dry overnight.
PETG is recommended.
A few pointers:
I'd recommend scaling this model for 140% (or even more if you have big birds flying around).
This can be printed without support although it may struggle some at the center of the bowl. If you encounter issues with it leaking water here, either increase the number of roof/bottom layers or spread some Gorilla glue on the bottom to dry overnight.
PETG is recommended.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
