Thingiverse
Plastic Knuckles
por Bocnov
93
Descargas
67
Likes
0
Makes
I have designed these "brass" knuckles with FreeCAD and I am pretty satisfied with the results, since I still am pretty new in the 3D printing universe.
80% or higher infill is recommended in order to obtain a print dense enough.
Also, the size depends on how big your hands are. In my case it was 90% the original size, which I strongly recommend.
IMPORTANT: This is intended to be used only as a self defense weapon in an extreme emergency case. Do not use it to harm anyone, as it could cause serious injuries.
80% or higher infill is recommended in order to obtain a print dense enough.
Also, the size depends on how big your hands are. In my case it was 90% the original size, which I strongly recommend.
IMPORTANT: This is intended to be used only as a self defense weapon in an extreme emergency case. Do not use it to harm anyone, as it could cause serious injuries.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!