Plastic Waste Bin Port

This is a trash shoot with a magnetic lid. Made to be mounted into the work surface so any printer scraps can be swept into the waste port. This uses ¼"x¼" magnets but 6mmx6mm magnets work as well with some superglue. Just be sure to check the polarity of the magnets before pressing them into the model. Base INSTALATION:To mount the base plate, place the part on the table where you'd like it to sit. Trace it out the contour on the table and cut it out using a jigsaw or somthing similar. I Drilled holes in the corners of the contour so I had a place to start the cut.Insert the base plate in the hole and glue in place if necessaryInsert the magnets into the base plate facing the same directionInsert the magnets into the lid facing the opposite direction Box Mounting:Find a box you want to use and trim the flaps to fit the printed mountMount the printed parts under the new hole with space to slide the box in and out for emptying ¼" Magnet Link: https://www.amazon.com/Refri