Thingiverse
Platform Multipurpose Tube Brackets
von SimonD09
13
Downloads
19
Likes
0
Makes
Bought a 5 pack of 19mm Wardrobe Rails from Toolstation which were under £10 for 5 x 1.2 Mtrs for another project and had loads left over so came up with a design for platform legs.
In this case I had an A4 sheet of 3mm Acrylic sheet so made a riser display stand but you can use them on pretty much any material, MDF, glass etc.
Base is snug fit and the feet stay on but if you want it permanent I suggest a blob of glue.
Top has cutouts for 3mm nuts and are a press fit, holes are for 3mm screws.
Again a blob of glue in the if you want the tube permanently fixed.
In this case I had an A4 sheet of 3mm Acrylic sheet so made a riser display stand but you can use them on pretty much any material, MDF, glass etc.
Base is snug fit and the feet stay on but if you want it permanent I suggest a blob of glue.
Top has cutouts for 3mm nuts and are a press fit, holes are for 3mm screws.
Again a blob of glue in the if you want the tube permanently fixed.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!