Thingiverse
PLAtform Shoes
von EmmaKwaz
233
Downloads
213
Likes
0
Makes
These PLAtform Shoes are 3D-printable, flexible sandals using PLA.
Designed for a women's 7-7.5 foot, but can be scaled up or down!
The platform part of the shoe is the 3D-printable component.
Then, you can weave the straps through the slots on the side of the shoe, hot glue them to the sole, then create a leather sole out of hot-glued thin layers of leather or pleather.
Necessary extra supplies (all available from Joanne Fabrics):
Thick leather strap, 1.5" wide, 1.5 ft long
Stretchy fabric, 1.5" wide, 1 ft long
Leather or pleather cloth (1/2 square meter)
I've also attached the STL file for a Ninjaflex insert. If you can print Ninjaflex and would rather not make the leather sole, then try this out!
Final note: these shoes are squeaky on concrete so I am working on attaching some material to the bottom (leather, rubber, etc.) to dampen the sound.
Designed for a women's 7-7.5 foot, but can be scaled up or down!
The platform part of the shoe is the 3D-printable component.
Then, you can weave the straps through the slots on the side of the shoe, hot glue them to the sole, then create a leather sole out of hot-glued thin layers of leather or pleather.
Necessary extra supplies (all available from Joanne Fabrics):
Thick leather strap, 1.5" wide, 1.5 ft long
Stretchy fabric, 1.5" wide, 1 ft long
Leather or pleather cloth (1/2 square meter)
I've also attached the STL file for a Ninjaflex insert. If you can print Ninjaflex and would rather not make the leather sole, then try this out!
Final note: these shoes are squeaky on concrete so I am working on attaching some material to the bottom (leather, rubber, etc.) to dampen the sound.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!