Thingiverse
Platsa Screw Spool Holder
by kain90
9
Downloads
6
Likes
0
Makes
This remix comes from the need to unroll the reel without sliding it along the filament holder.
Thanks to the nut and counter nut you can stop the spool in the correct position so that the filament runs straight inside the PTFE tube.
It is also possible to change the coil without the use of tools (screwdriver) in the case of coils with a hole of less than 50mm.
About 6H the printing time
N.B. Do not overtighten the nut to allow the reel to slide effortlessly
Thanks to the nut and counter nut you can stop the spool in the correct position so that the filament runs straight inside the PTFE tube.
It is also possible to change the coil without the use of tools (screwdriver) in the case of coils with a hole of less than 50mm.
About 6H the printing time
N.B. Do not overtighten the nut to allow the reel to slide effortlessly
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!