Slicer Discord
Playdate magnetic charging stand – Modelo 3D imprimible de MakerWorld MakerWorld
Gadgets

Playdate magnetic charging stand

por tjjos · Gadgets
31 Descargas
10 Likes
18 Makes
Ver Modelo
A magnetic charging stand for the Playdate. It uses eight round 8mm x 1.5mm (or four 8mm x 3mm) neodymium magnets for the corners (two for each) and four rectangular 5.75mm x 19mm x 1.75mm for the center. The magnets are connected to a standard 5v USB 2.0 charging cable (red goes to the top magnet and black goes to the bottom magnet). Then use the provided cable caps (cylinders) to firmly press the cables onto their place. To complete the setup, wrap the USB cable around the center “roundabout” piece and guide it through the bottom opening. Finally close the stand by pressing the back cover onto it (snap-on). The stand can be printed without supports but you need to add stops at layer 10 (to add the center magnets) and 16 (to add the corner magnets). Otherwise add supports for the corner and center holes. The base of the stand is hollow so that you can add a stop at layer 190 to add pennies/sand/gravel to add weight to the stand.Apart from the Playdate console, it can also be used for:
Categoría
Gadgets
Fuente
MakerWorld
Publicado
Actualizado
Lo que necesitas para imprimir: Intermedio Baja confianza
¿Por qué?
sin soportes · postproceso considerable
Sin soportes Pieza única Tornillería requerida
Soportes 0/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 2/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
PLA
Postprocesado
Lijado, Tornillería
Software
Cura, PrusaSlicer o similar
Mismo diseñador, más plataformas

tjjos también publica en

15 modelos adicionales en 1 plataformas más

Verificado por coincidencia de títulos de modelos entre plataformas.
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección