Playdoh Hand Extruder

Our Playdoh kit was missing an extruder.. so I designed one! It just so happens that PLA doesn't stick very well to Playdoh which makes it a perfect choice for this application. Unfortunately I only had this boring blue-gray filament kicking around.. but I'm sure that some other colour choice would really make this pop! The extruder barrel even has some star imprints on it which can be used to texturize your Playdoh creations! Quick Tip - Once printed run the strip through the tabs a few times until it starts sliding smoothly and you're good to go! If you like this print don't forget to rate, comment and boost! Enjoy! Update [2025-01-15]: Adjusted tab width to increase strength. Print can now also be printed without any supports! Also improved print quality with variable layer height. If you had already printed the full set and want to upgrade to V2, you just need to print the new main barrel and you're good to go! Update [2025-01-17]: Increased Wall loop from 3 to