Thingiverse
Playing card case
von moritz_l
39
Downloads
36
Likes
0
Makes
Playing card case
93 x 68 x 21 mm
Infill doesn't matter as long as you set 3 perimeters.
PLA and PETG are working fine, every other material probably too, but rubber-like materials are not that benificial in this case. Even if the case is made out of them.
I created this thing because I didn't like the existing card cases or they were too big or stingy.
93 x 68 x 21 mm
Infill doesn't matter as long as you set 3 perimeters.
PLA and PETG are working fine, every other material probably too, but rubber-like materials are not that benificial in this case. Even if the case is made out of them.
I created this thing because I didn't like the existing card cases or they were too big or stingy.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!