MakerWorld
Office
Ver Modelo
Playstation Pulse Elite Headset Fix
112
Descargas
25
Likes
59
Makes
Please like if this model helps you!Some people have found that wedging cardboard between the bracing and the headset frame works just as good as superglue so maybe give that a try before you commit to the glue.Simply print the necessary parts (V1 Revision 13 is the latest) then slide them on from the bottom and use superglue to secure as best you can. Depending on where your headphones snapped you may or may not need the connecting peice (i personally didnt).Its not pretty but its not meant to be :)If you want something changed leave a comment and ill see if i can do it.Printed in PLA, no supports needed. 15% Infill, 4 walls, Inner/Outer wall order and there should be no problems printing. 5mm brim recomended.Where to apply superglue:Slide the cover onto the headphones, it should be pretty self explanitory, but it can be a little tricky to get on.Move the cover up/down till the bottom of the cover is ~2cm below the crack as shown in the first image. (Note it will be quite loose).Apply
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!