Thingiverse
Pliers stand
von Advinge
41
Downloads
34
Likes
0
Makes
Pliers stand.
If you want the sides to look like in the photo you have to configure the laminator for zero upper and lower layers and choose the filling pattern that you like.
Two copies of the sides and three copies of the rails are printed.
Then glue it all together with a little instant glue.
It is recommended to print the crosspieces with enough percentage of filling to support the weight of the pliers and not to bend.
If you want the sides to look like in the photo you have to configure the laminator for zero upper and lower layers and choose the filling pattern that you like.
Two copies of the sides and three copies of the rails are printed.
Then glue it all together with a little instant glue.
It is recommended to print the crosspieces with enough percentage of filling to support the weight of the pliers and not to bend.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
