Thingiverse
Ploder Dishrack Lift
door memoryone85
1
Downloads
1
Likes
0
Makes
The dishrack that I have, by Ploder, did not have enough tilt to fully drain the water. Designed and printed this out to slot right over the existing rubber feet. This may work for other Ploder dishracks or maybe other dishracks of similar design.
The front are 11mm in total height, adds 2mm to the overall height.
The rear are 25mm in total height, adds 14mm to overall height.
Rear lift height is subject to change as its not quite draining as fully as I like, some water stays in the lip of the pans.
The front are 11mm in total height, adds 2mm to the overall height.
The rear are 25mm in total height, adds 14mm to overall height.
Rear lift height is subject to change as its not quite draining as fully as I like, some water stays in the lip of the pans.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!