Thingiverse
Plug Spinner
von Phreak87
14
Downloads
5
Likes
0
Makes
this parts are needed to build your own plug spinner:
(if you picked a lock you can jump over the pin-line)
1. Print all parts
2. put the cylinder parts together (leave place for the spring)
3. put two springs inside the mechanism (this can be tricky)
4. take a lighter and melt the bolt
5. Press the melted part down with a metall so that the two rings can move freely.
6. Mount the key on the side with a M3 screw.
Now you can tighten the spinner until the lock is set and push the
button to release to start the spinning.
(if you picked a lock you can jump over the pin-line)
1. Print all parts
2. put the cylinder parts together (leave place for the spring)
3. put two springs inside the mechanism (this can be tricky)
4. take a lighter and melt the bolt
5. Press the melted part down with a metall so that the two rings can move freely.
6. Mount the key on the side with a M3 screw.
Now you can tighten the spinner until the lock is set and push the
button to release to start the spinning.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
