Slicer Discord
Pocket LED Flashlights – 3D-Druckmodell von Thingiverse Thingiverse

Pocket LED Flashlights

von Lyl3
30 Downloads
65 Likes
0 Makes
Zum Modell
###Pocket LED Flashlights###

A small LED flashlight powered by a CR2025 or CR2032 coin cell (battery) that can be attached to a key ring.

These are great little flashlights for short little tasks where you only need a little bit of light for a few seconds. The banana in the first image is there for scale. Keen observers will notice that it's not a real banana and is actually a 5x3 LEGO block. The flashlight is about the same width and length as the block but only half the height..

I suppose typical usage might be to attach it to a keyring and use it to find a keyhole in the dark, but I have several of these placed around the house that I've been using for a few years and have found them to be very useful for other tasks. I have one on my night table to find my glass of water in the dark. I have one on a table that's handy for checking if the front door is locked.. I have one on my computer desk to see the keyboard so that I can unlock the computer. Fumble in the dark, turn o
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Mindest-Druckbett
50 mm (Klein)
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen