Thingiverse
Pocket operator rear protector
por Volectorus
17
Descargas
14
Likes
0
Makes
Pocket operator contact protector and finger rest compatible with Teenage Engineering silicone case.
When holding the pocket operator comfortably, my finger was resting on the potentiometer contacts and causing interference on my settings.
This will take care of the interference and sits on the balance point of the device which also makes a good finger rest.
This will fit snug and wont move unless you want to slide it off to remove it.
Install it by sliding it into place from rear of device. (make sure the gap on print fits over the potentiometers raised contacts. ( the silicone will have enough flex to carefully lift it over the contacts and set it.)
When holding the pocket operator comfortably, my finger was resting on the potentiometer contacts and causing interference on my settings.
This will take care of the interference and sits on the balance point of the device which also makes a good finger rest.
This will fit snug and wont move unless you want to slide it off to remove it.
Install it by sliding it into place from rear of device. (make sure the gap on print fits over the potentiometers raised contacts. ( the silicone will have enough flex to carefully lift it over the contacts and set it.)
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
