Pocket Push Racer

A simple free-wheeling toy car that fits in your pocket or bag. Check out the Rubber Band Racer here. Give me a 👍 and 🚀 if you enjoyed this 🙂 more designs and commercial rights available on my Patreon. It'll roll effortlessly with just a light push or just blow air at it; the harder you push, the farther it'll go; rolls on it's own on a downhill. Please make sure your build plate is clean and free of grease and oil before printing. Although it didn’t happen in my testings, there are reports of it failing near the end of the print. If this happens to you, your build plate isn’t as clean as you think it is. Good luck 🙂 I recommend using PLA-CF, they look great and add a bit of strength to the model. Other materials will work just fine. Parts needed to complete the build: 4 MR128 Steel Deep Groove Ball Bearings8 24x2.5mm O rings OR 8 1.4x20mm Basic rubber bands check out BOM for links or get them from Amazon: Bearing O ringsRubber band Due to its unibody design, it could b