Thingiverse
Pocket Toothpick Dispenser
door Pattersaurus
2
Downloads
10
Likes
0
Makes
Fits toothpicks up to 68mm in length. About the size of a lighter, maybe a little taller. Inside lid is curved to reliably feed toothpicks to the dispensing hole, but also has the added benefit of printing nicely without supports.
20% Infill (but doesn't really matter)
Print with no supports.
I found that some filaments will cause the plug to fit too tightly. If this happens, decrease the width of the plug in your slicer from 6mm to 5.8mm.
20% Infill (but doesn't really matter)
Print with no supports.
I found that some filaments will cause the plug to fit too tightly. If this happens, decrease the width of the plug in your slicer from 6mm to 5.8mm.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
