podracer toothpick canopy

having recieved a gtb 329 frame, just to find out that it doesnt match the picture and doesnt have a 16x16 mount, i decided to make my own canopy and mount. I decided to replicate the tbs podracer format, because it allows the camera to be mounted lower than if the camera was mounted in the front.

Living in denmark, where it's cold and wet, so i have semi-sealed the canopy and have sacraficed a bit of weight to do so. the orginal canopy was 4g, but required 3x metal standoffs and 6 screws to mount. test print weighs 5g without bolts, but without the need of standoffs, this is lighter by an easy 5g.

designed for
--caddx baby ratel 2
--16x16mm JHEMCU GHF13
--betafpv air ufl 5.8ghz antenna
--xf-race antenna on r9 mx

measured to fit an r9 mx and zeus nano vtx under the canopy. but any nano reciever/vtx will probably fit.

camera angle is not setup to be adjustable, and fixed at 20 degrees.

Final assembly will only require 4x 10mm m2 bolts to hold the fc and canop