pokèball pokemon

Lascia un boost se ti piace il mio lavoro per incentivarlo. trovi anche altri modelli simili sul mio profilo Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmThe Model is 200x200mm in sizeYou may print at higher layer heights below the Min Depth of 0.88mmThe Max Depth is 2.2mm and the Actual Depth is 2.3mmFilaments Used: PLA PolyLite White Transmission Distance: 5 PLA+ Sunlu Red Transmission Distance: 6 PLA PolyLite Black Transmission Distance: 0.3This print uses 3 unique filamentsSwap Instructions: Start with White At layer #13 (1.12mm) swap to RedBorder Only Colors from here until the end. At layer #23 (1.92mm) swap to BlackThis slider is set higher than the mesh depth. It is not affecting your final mesh. Consider removing it. At layer #29 (2.4mm) swap to Red for the rest.