Pokeflute

I was making some Snorlax Google Nest holders for a coworker and I was asked about a pokeflute. I found this one on Thingiverse but it looked problematic when I put it in the slicer. Since it is basically a bunch of geometric shapes, I went and modeled it myself from scratch. Unfortunately, this model also doesn't “work.” Covering some of the holes and blowing will change the pitch, but it doesn't play like a flute or whistle. It's just a different pitched exhale. Normally I'd restrict my models, but I would legitimately like to see a remix that works like a recorder on this basic frame. Either way, it is a fun little trinket. As a note, I printed this twice with supports. I haven't attempted without supports because I'm not sure it can since there are a couple of overhangs. When printed with supports, it also prints a support down the center which I remove by inserting a deburring tool into each hole and pushing the support downwards until it releases and falls