MakerWorld
Hueforge & Lithophane
Zum Modell
Pokemon Bookmark
52
Downloads
32
Likes
35
Makes
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.24mm The Model is 53.41x203.81mm in size You may print at higher layer heights below the Base Thickness of 0.56mm The Max allowed Thickness is 2.32mm and the Actual Thickness is 2.31299mm #000000 PLA Sunlu Meta Black Transmission Distance: 1 #989898 PLA Jayo Grey Transmission Distance: 1 #ffffff PLA+ Sunlu White Transmission Distance: 2.1 #ff0000 PLA Jayo Red Transmission Distance: 2.5 This print uses 4 unique filaments Swap Instructions: Start with Sunlu Meta Black At layer #12 (1.12mm) swap to Jayo Grey (Grey can be removed if needed) At layer #18 (1.6mm) swap to Sunlu White At layer #21 (1.84mm) swap to Jayo Red for the rest.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
