Thingiverse
pokemon quest magikarp
door eggrole7
28
Downloads
20
Likes
1
Makes
direct model sliced from https://www.models-resource.com/mobile/pokemonquest/model/25883/
prints well at 100mm on the y-axis
i used tree supports and both whiskers fell off and had to be glued back on, just be careful around those bits and you should be fine
prints well at 100mm on the y-axis
i used tree supports and both whiskers fell off and had to be glued back on, just be careful around those bits and you should be fine
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
