Thingiverse
PoKeys57E Case
von geeran8601
1
Downloads
2
Likes
0
Makes
This is a pcb cover plate for the PoKeys57E Board so flying wires dont short out the bottom.
The M3 can go through when using longer screws are used or be flush when using M3x5 or M3x4.
Total height top pcb to bottom is 5.3mm.
Should work with the PoKeys57U since the USB is smaller but not tested.
Added struts so it bends less and a cutout for the serial number.
Remove the mouse bites on the pcb edge and press in while the top layer is still warm for a good fit.
The M3 can go through when using longer screws are used or be flush when using M3x5 or M3x4.
Total height top pcb to bottom is 5.3mm.
Should work with the PoKeys57U since the USB is smaller but not tested.
Added struts so it bends less and a cutout for the serial number.
Remove the mouse bites on the pcb edge and press in while the top layer is still warm for a good fit.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!