Thingiverse
polish
von WillandMrData2
1
Downloads
0
Likes
0
Makes
Polish
Possible print notes,
Hum started off as is with .1mm floating position,
tho since i'm here typing it seems apparent that perhaps a zero floating position seems to make for a closer finnish.
So in that case run again with place on surface print. and negative if required.
Some possible notes,
else,
s= (print -xyz +(Pa>
Possible print notes,
Hum started off as is with .1mm floating position,
tho since i'm here typing it seems apparent that perhaps a zero floating position seems to make for a closer finnish.
So in that case run again with place on surface print. and negative if required.
Some possible notes,
else,
s= (print -xyz +(Pa>
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!