Polycarbonate square support 3mm

Straight and L-shaped supports, for 3mm thick polycarbonate and quick to put on and take off.
Enclosure to maintain temperature and to improve 3D printing with ABS.

To consider:
The programmed zigzag support, generates too much support and then leaves the face rough. You can program a less dense support, to achieve a better surface finish.

Configuration in CUra:
Layer height: 0.2mm
Initial layer line width: 100%
Wall thickness, and upper and lower bases: 1.2 mm
Fill: 30%
Printing temperature: 200 C
Hot bed temperature: 60 C
Flow: 100%
Print speed: 60mm / s
Filling speed: 60mm / s
Wall speed and initial layer: 30 mm / s
Retraction: Enabled
Retraction distance: 5 mm
Retraction speed: 60 mm / s
Refregeration: 100% activated
Support: Yes zigzag