Thingiverse
Polycaster - 3D Printed Guitar
door AndyDoesGuitar
455
Downloads
315
Likes
2
Makes
The Polycaster is a design I've been working on for a while and finally decided to print it. The main body is made up of 6 pieces that I've epoxied together. The main middle part was printed with 100% infill and uses almost an entire roll of filament. The outer 5 pieces were printed at either 15% or 25% infill, depending on the piece. The pieces that hold screws were 25% infill, and the rest of them were 15%. This way I was able to print all of those parts with a single roll of filament.
The neck pocket and bridge design were based on the specs of a 60s Stratocaster. With a 25.5" scale neck, you should be able to use any Fender Stratocaster neck or any aftermarket neck designed to be Fender replacement necks. I had a third party neck I ordered off eBay for a different project lying around, so that's what I decided to use.
This was a long one. All together, the total print time ended up being about 9 days. The main piece that is 100% infill took about 2 1/2 days, the other body pi
The neck pocket and bridge design were based on the specs of a 60s Stratocaster. With a 25.5" scale neck, you should be able to use any Fender Stratocaster neck or any aftermarket neck designed to be Fender replacement necks. I had a third party neck I ordered off eBay for a different project lying around, so that's what I decided to use.
This was a long one. All together, the total print time ended up being about 9 days. The main piece that is 100% infill took about 2 1/2 days, the other body pi
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
