PolyDryer Adapter Plate

I wanted to connect the new Polymaker PolyDryer to my larger container, so I designed this adapter plate to fit the PolyDryer to any container. I had some issues cutting holes in my box without cracking the plastic, so I created the cutting guide plates to go with it. PartsM3x12mm+ FHCS - Qty. 8 (These will depend on the thickness of the container you are installing the adapter plate on)M3 Nuts - Qty. 8 (If using the cutting guides. These are just temporary to hold the cutting guides in place)M3 X D5 X L4.0 Heat Set Inserts - Qty. 8TPU FilamentPETG, ABS, ASA, or PA filament (Really any filament with higher glass transition temps) Cutting GuidesTo use these plates, you want to tape one down (the two cutting guides are the same) on the outside of the container in the place you want the dryer to mount. Then use a drill bit to drill the holes for the 8 screws. Place the second cutting guide plate on the other side of box and screw the two plates using some M3 screws (the length of these wi