Polygonal Snowman

I have spent over a month designing this model! You can remove and flip the arms up or down for various poses.

NOTE: You must adjust the settings for each part, the eyes and buttons are slightly different sizes from each other and they should be labeled in Cura (check bottom left corner with file open), take care when doing any post processing on the pieces as they may break.

There are settings included for two different types of filament, a clear color, and a solid color. I highly recommend using Gyroid infill if you have any clear filament as the pattern gives it an extra flair. I sometimes sand down the buttons after clipping them, or just flip them upright with supports then clip the insert portion.

The Snowman Body has a support blocker on the Right Eye because Cura was placing support in there when it's not needed unless the scaling is up much higher.


PRINTED using Anycubic Kobra.

IMPORTANT License Info for these files and design:

https://creativecommons.org/l