PolyMaker adapter for BambuLab spool

Tired of not always being able to close your AMS fully, when using ring adapters on your Polymaker cardboard spools?Want to avoid cardboard remains in your AMS, and also not have the filament spin around the spool you installed it on? Look no further - This print is the solutionBy installing these two rings on your Bambu reuseable spool you'll be able to insert it firmly into your Polymaker filament. When installing place a ring on each half of the bambu spool, make sure you place the key'ed ring on the corresponding spool half. Then you need to remove the cardboard on one side at a time from your Polymaker filament and install one of the reuseable spool halves, before removing the cardboard on the other side. This will ensure that your filament doesn't fall out to the sides.When both sides are installed you'll be able to spin the spool around and lock it in placeWatch the GIF for installation guidance Be sure that the spool is locked in position, if not proberbly secur