Pool Cue Holder

There are two ways to use this. If you want to add the self-adhesive non-slip tape (see link below), you'll need to install the washer between the arms and the body to make up the thickness of the tape. If you just want to skip the tape, leave the washers out. It works great either way.

Super easy print. No supports needed.

Orient the arms with the large opening facing up.

Orient the pins fat part to the plate.

Print with a very high infill for added heft (I use 60%), but not needed for strength.

Assembly is pretty straight forward, but upon final assembly, put a drop of some kind of glue in the hole for the pins. I use 5 minute epoxy, but Cyanoacrylate Adhesive would be fine too (super glue).

Here is the self-adhesive non-slip tape I used. https://www.amazon.com/dp/B0CS2PT17T?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1