Thingiverse
Pool Shark Pool Claw
door jeremykc1977
26
Downloads
15
Likes
0
Makes
A claw to hold your stick off a table. Dont let your expensive pool stick fall to the floor. You're a pool shark, you might as well announce it too.
you'll need supports. 10% infill is sufficient, but to give it some heft, I went 25%. also glue a rubber non slip mat under it, to help hold it in place.
you'll need supports. 10% infill is sufficient, but to give it some heft, I went 25%. also glue a rubber non slip mat under it, to help hold it in place.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
