Thingiverse
Pool Vacuum Handle Repair
von pcon2009
29
Downloads
17
Likes
0
Makes
Remixed the part by pouletgrill to fit my Intex brand pool vacuum head. The part that fits into the pole was perfect, but the "fingers" (for lack of a better term) were too wide to fit into my vacuum attachment which has slots about 2.5mm wide. The spacing between was about right, but just needed to thin it down a bit.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!