Thingiverse
Pool vacuum
von i6o6
69
Downloads
62
Likes
0
Makes
A simple (yet very effective) pool vacuum system. The project consists of 3 parts to be printed and a 1" hose to be bought at your local hardware store.
The wand-slang connector fits into the suction port of your pool. The hose has a spiral on the outside and the connector can be screwed on the hose.
Zuigmond_1 and _2 have to be glued together (2 parts are easier to print) and can be screwed on the hose aswell.
Have been testing it for three weeks now and works fine (didn't finish vacuuming on the picture). Don't forget to clean your filter ;-)
I hope you enjoy this print!
The wand-slang connector fits into the suction port of your pool. The hose has a spiral on the outside and the connector can be screwed on the hose.
Zuigmond_1 and _2 have to be glued together (2 parts are easier to print) and can be screwed on the hose aswell.
Have been testing it for three weeks now and works fine (didn't finish vacuuming on the picture). Don't forget to clean your filter ;-)
I hope you enjoy this print!
i6o6 veröffentlicht auch auf
32 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
