Thingiverse
Pop shield clamp
por splabble
3
Descargas
1
Likes
0
Makes
A threaded pop shield/pop filter clamp designed to replicate the standard clamp that come with cheaper pop shields like the one pictured.
Printed at 0.2mm layer height with 60% infill, plus a 100% infill in a cube around the bolt hole. No supports.
Uses a M4 x 25mm bolt and nut. The nut is optional as the screw should self tap to a degree in the plastic, however this is unlikely to be very strong.
Watch out for excessive elephants foot as this could make it hard to get the pop shield screw in.
Printed at 0.2mm layer height with 60% infill, plus a 100% infill in a cube around the bolt hole. No supports.
Uses a M4 x 25mm bolt and nut. The nut is optional as the screw should self tap to a degree in the plastic, however this is unlikely to be very strong.
Watch out for excessive elephants foot as this could make it hard to get the pop shield screw in.
splabble también publica en
7 modelos adicionales en 2 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
