Thingiverse
Popsicle Stick Connectors
door 3d-printy
399
Downloads
273
Likes
1
Makes
This is a remix of the **PopSticks** toy by Irv Shapiro.
This alternate design cuts a few corners - hopefully in a good way! Both the connectors and the extenders can be printed without supports (in the orientation shown above), but a brim may be needed unless you have *very* good bed adhesion.
"tight" variants have also been added, but the regular versions are recommended.
https://youtu.be/TddTyZ7HkIQ
https://youtu.be/TddTyZ7HkIQ
This alternate design cuts a few corners - hopefully in a good way! Both the connectors and the extenders can be printed without supports (in the orientation shown above), but a brim may be needed unless you have *very* good bed adhesion.
"tight" variants have also been added, but the regular versions are recommended.
https://youtu.be/TddTyZ7HkIQ
https://youtu.be/TddTyZ7HkIQ
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!