Thingiverse
PopSocket MagSafe retrofit base
by Three2juan
13
Downloads
13
Likes
0
Makes
Introduction
I created this base because I wanted a PopSocket but didn't want to glue it to my new MagSafe case. Similar items go for $30+ so designing this was a no-brainer.
Materials
Printer/PLA
MagSafe sticker: can be found on Amazon, eBay, etc.
PopSocket or whatever holder thing you like
Instructions
Print the front plate first which is about 1mm thick. DO NOT remove the print, leave it on the bed
Put the MagSafe sticker facing down
Print the back plate on top of the front plate. Set a Z-Axis offset of about 1mm
Remove the finished base from the bed
Attach your PopSocket on the circular marker
I created this base because I wanted a PopSocket but didn't want to glue it to my new MagSafe case. Similar items go for $30+ so designing this was a no-brainer.
Materials
Printer/PLA
MagSafe sticker: can be found on Amazon, eBay, etc.
PopSocket or whatever holder thing you like
Instructions
Print the front plate first which is about 1mm thick. DO NOT remove the print, leave it on the bed
Put the MagSafe sticker facing down
Print the back plate on top of the front plate. Set a Z-Axis offset of about 1mm
Remove the finished base from the bed
Attach your PopSocket on the circular marker
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!