MakerWorld
Sport & Outdoors
Go to Model
Portable Hangboard
25
Downloads
15
Likes
15
Makes
Portable Hangboard designed for warming up at the crag! Works well to increase finger strength when attaching to a kettlebell at home or the gym. Contains a 20mm, 15mm, and a 10mm edge. FILAMENT: ASA, ABS, NYLON PRINT SETTINGS: Highly recommend using at least 4 walls; support material is not needed. HARDWARE: 6 EA M4 heat-set inserts, 6 EA M4x20, Optional: Glue ASSEMBLY: Install the heat-set inserts into “Outer Shell Part 2.” Sandwich the center hub in between the two outer shell pieces. Install the bolts through the “Outer Shell Part 1.” Alternatively, you can add glue or epoxy to each Side of the V on the Center Hub and clamp the outer shell pieces on to cure.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!