Thingiverse
Portable LCD stand
por jxoco
0
Descargas
0
Likes
0
Makes
This is a remix of desktop monitor stand.
I need it to hold up a 15.6 inch portable monitor for a laptop, actually a Raspberry PI.
The notch on the original was not big enough to hold the thicker monitor and the leg was not long enough to prevent the monitor from toppling over backwards.
The Youdoit monitor is 12mm thick.
There is about 2mm to run cables under the monitor, so you might want to modify it so that there is a bigger gap under the monitor.
It is very simple and pretty quick to print. You print two of them.
I printed them in PETG and at 65% fill.
I need it to hold up a 15.6 inch portable monitor for a laptop, actually a Raspberry PI.
The notch on the original was not big enough to hold the thicker monitor and the leg was not long enough to prevent the monitor from toppling over backwards.
The Youdoit monitor is 12mm thick.
There is about 2mm to run cables under the monitor, so you might want to modify it so that there is a bigger gap under the monitor.
It is very simple and pretty quick to print. You print two of them.
I printed them in PETG and at 65% fill.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
