Thingiverse
Portable Nintendo Switch Adjustable Holder
door MoreThan2D
5
Downloads
8
Likes
0
Makes
This is a Nintendo switch mount I came up with as I wanted something compact and easy to travel with. There are a few others out there which meet the category, just not what I wanted. The photos attached show the part printed at 0.1mm layer height, @60mm/s, with 0% infill and 10% support with 8mm brim.
Use support for both pieces. Print the base laid flat as you would use it. Print the top piece vertical.
All that is required to finish is 2x m3x15mm bolts and 2x m3 nuts.
Use support for both pieces. Print the base laid flat as you would use it. Print the top piece vertical.
All that is required to finish is 2x m3x15mm bolts and 2x m3 nuts.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
